FloPlast supplies a universal rise-and-fall bracket that comes with a spike to set into mortar between brickwork, allowing you to fix the fascia bracket. Alternatively, rafter brackets can be used to fix directly onto the side or top of a rafter.
How do you make a swan neck downpipe connection?
To make a swan neck bend, connect two 112.5° offset bends together.
How do you stop a union bracket from leaking?
Inspect the union bracket for improper installation, which could cause the gutter to pull out of the bracket. Ensure the gutter is installed to the correct markings to allow for expansion and contraction.
How much of FloPlast gutter is made from recycled plastics?
FloPlast gutters are made from up to 20% recycled plastics, in accordance with British Standards. The gutter system is also fully recyclable after use.
How much room do I need to leave for the expansion of the gutter?
Gutter expansion during normal usage is approximately 10mm per 4-meter length, though this can be as much as 14.63mm under extreme temperature fluctuations between -8ºC and +40ºC.
When should silicone spray be used?
FloPlast recommends using silicone spray/lubricant on all gutter installations, especially on fittings with seals. Avoid using washing-up liquid, as it may damage rubber seals.
Where and how far apart should downpipe clips be placed?
Downpipe clips should be positioned below the sockets of offset bends, joints, branches, and shoes, with a maximum distance of 1.8 meters between clips.
Which screws should be used to secure fascia brackets to fascia boards?
Use 25mm x 5mm non-ferrous round head screws for a 2-hole fixing, and 40mm x 5mm non-ferrous round head screws for a 1-hole fixing. Countersunk screws are also suitable if care is taken not to overtighten, particularly when using power tools.
