PVC Guttering

Fascias and Soffits

External Cladding

Internal Cladding

Hygiene Cladding

Underground Drainage

Soil and Waste

Decking

Flooring

Fibre Cement Cladding

Polycarbonate and Acrylic Sheets

Roofing and Glazing Bars

Planning and Components

Utilize component diagrams to determine the type and quantity of products required for your installation.

Fascia Bracket Spacing:

Straight Gutter Runs: Maximum spacing of 1 metre.
Niagara System: Maximum spacing of 800mm.
Xtraflo System: Maximum spacing of 600mm.
80mm Round Downpipe with Hi-Cap and Niagara Systems: Maximum spacing of 800mm.
High Snowfall Areas: Maximum spacing of 400mm.

Fitting Support:

Removing Old Components

Remove the old gutter and replace any old fascia board with Swish low maintenance PVC-UE co-extruded fascia board.

Installing Running Outlet

Determine the position of the running outlet, typically over an existing drain, and secure it to the fascia board.

Fixing Fascia Brackets

Fixing Procedures

Fascia and Union Brackets: Position to avoid splitting the top edge of the timber fascia board. Use two 25mm x 5mm (1” x 10) screws or one 40mm x 5mm (1½“ x 10) screw for all brackets. "Cast Iron" fascia brackets must be secured with two fixings.
Unions: Fixed using a 25mm x 5mm (1” x 10) screw.
Outlets and Angles: Fixed using two 25mm x 5mm (1” x 10) screws.
Heavy Snowfall Areas: Each fascia bracket should be secured with two 25mm x 5mm (1” x 10) screws.
Rainwater Downpipe Clips: Use two 40mm x 6mm (1½“ x 12) screws.
Screw Types: Round head screws are preferred; counter sunk screws can be used with caution to prevent overtightening.

Lubrication

Lubricate all gutter seals with FloPlast silicone spray lubricant for easy fitting and to accommodate expansion and contraction.

Gutter Assembly

Starting from the running outlet, insert the back edge of the gutter under the retaining lip of the wrap-around clip.
Apply slight downward pressure to snap the front edge of the clip over the front of the gutter, ensuring to maintain the marked expansion allowance.

Joining Gutter Lengths

Use a union bracket or angle to connect the next gutter length, finishing the run with a stopend.

Downpipe Installation

Start the downpipe installation at the outlet.
For offsets, use two offset bends (with or without a short pipe) or an adjustable offset bend.
Ensure a 6mm gap at the top of the downpipe for expansion.
Secure pipe connectors to the wall with a pipe clip.
Fit a shoe at the base of the pipe secured with a pipe clip or connect the downpipe to an underground drainage system using a 110mm x 68mm reducer (SP96/D96 or D97).

Additional Notes

Refer to the snow loading statement on page 26 for detailed guidelines regarding snow load considerations.
Always ensure all fixings are secure and follow local building regulations and standards during installation.